Comparison of mechanical properties of ground corn stover,switchgrass, and willow and their pellet qualities

Mechanical and physical properties of ground corn stover, switchgrass, and willow were measured and compared in addition to the quality of pellets. Biomass was size-reduced with two different screen sizes (3.175 and 6.35?mm) and conditioned to obtain samples at two different moisture contents (17.5 and 20% on wet basis). Ground switchgrass had the smallest and willow had the highest D₅₀ when size-reduced with the same screen size. Hydrostatic triaxial compression tests were performed using the cubical triaxial tester to determine the bulk modulus, compression index, and spring-back index at specific unloading pressures (20, 45, 70, and 95?kPa). The trends of pressure vs. volumetric strain and void ratio vs. natural log of pressure were similar for all three materials; however, the magnitudes were different. Willow, size-reduced with 3.175?mm screen size at 17.5% wet basis, had the highest bulk modulus among different conditions of all the three biomass. Pellet durability values for all the three materials were higher than 80%. Corn stover pellets formed with 3.175?mm screen size at 20% wet basis had the highest diametral tensile and axial compressive strengths among different conditions for all the three biomass, however the values were not significantly different (p?>?0.05).     

An improved damage diagnostic technique based on Singular Spectrum Analysis and time series models

An approach to enhance the sensitivity of the damage index using the prediction errors of autoregressive – autoregressive exogenous models by augmenting Singular Spectrum Analysis (SSA) to detect and locate minor damage is presented. Numerical simulation studies are carried out by considering a simply supported beam with single and multiple cracks. An experimental study on a reinforced cement concrete beam has been carried out to validate the technique using different levels of damage. The studies emphasise that the SSA improves the sensitivity of the damage index for detection and also localisation, handling environmental/operational variability and measurement noise.     

Relating video game exposure,sensation seeking,aggression and socioeconomic factors to school performance

ABSTRACT

The time displacement hypothesis has been widely used to explain the effects of media use on academic performance. This approach has been criticised for its monocausality and weak explanatory power. Utilising a combination of different theoretical perspectives is better suited than utilising only one. Considering displacement, excitement, attraction and third variable hypothesis, this paper argues that the relation between video game use and school performance is not the same for all types of gamers by considering the influence of socioeconomic, psychological and contextual factors. It investigates how gaming patterns (frequency, time of day) and psychological characteristics (sensation seeking, aggression) are related to academic performance for primary and secondary school students. Five hundred and seven students from five primary and four secondary schools in Singapore participated in a paper-pencil survey. Results showed support for a combination of displacement and third variable hypothesis, as overall time spent on video games was negatively associated with primary school children’s and active gamers’ school performances. There was no significant relationship for secondary school children. For primary school children who play games in the morning and afternoon, video game use was negatively associated with school performance. There was no support for the attraction and excitement hypotheses.     

一种快速解压的无损压缩算法

随着信息技术的不断发展,大量数据给存储和传输都带来了巨大的挑战。数据压缩能够有效减少数据量,方便数据的处理和传输。无损压缩是一种利用数据的冗余特点进行压缩的压缩方法,解压时可以完全还原数据而不会有任何失真。在研究LZO算法的快速解压原理基础上,设计了一种新的压缩算法。该算法通过减少压缩数据中压缩块的数量,降低了解压程序的执行开销。测试结果表明,新算法可实现比LZO算法更快的解压速度。     

Structure of presented stimuli influences gazing behavior and choice

Well-structured stimuli presentation is essential in eye-tracking research to test predefined hypotheses reliably and to conduct relevant gazing behavior studies. Several bottom-up factors associated with stimuli presentation (such as stimuli orientation, size etc.) can influence gazing behavior. However, only a small number of scientific papers address these factors in a sensory and consumer science context and thus provide guidance to practitioners. The two presented eye-tracking studies on food images aimed at evaluating the effect of the bottom-up factors stimulus size, background of the picture, orientation of food product presentation, the evaluated products and the number of alternatives. Significant effects of product group were found in the case of all eye-movement parameters except time to first fixation and first fixation duration. In contrary, orientation significantly influenced only the time to first fixation and first fixation duration parameters. Stimulus size significantly increased fixation and dwell count, while background showed no significant effects. Furthermore, significant relationships were found between the number of presented images and eye-movement and decision time. Less time was needed in 2AFC (alternative forced choice test), 3AFC and 4AFC and significantly more time was needed to choose one alternative out of 7AFC and 8AFC. The results of the two studies show that the investigated bottom-up factors can significantly influence gazing behavior, and therefore need to be carefully considered when planning or comparing results of eye-tracking experiments.     

A novel low-latency DRAM based on the bitline-discharge rate

As well known by computer architects, the performance gap between the processor and the memory has been increasing over the years. This causes what is known as the memory wall. In order to alleviate the problem, a novel fast readout scheme is proposed in this article for the single-transistor single-capacitor dynamic random-access memory (1T-1C DRAM) cells. The proposed scheme works in the current domain in which the difference between the discharging rates of the bitline in the cases of ‘1’ and ‘0’ readings is detected. The proposed scheme is analysed quantitatively and compared with the conventional readout scheme. It is verified by simulation adopting the 45 nm CMOS Berkley predictive-technology model (BPTM) and shows 44 and 7.7% reductions in the average read-access and cycle times, respectively, as compared to the conventional readout scheme. It is also shown that the power is saved according to the proposed scheme if the probability of occurrence of ‘0’ storage exceeds 66.7%. This minimum value can be alleviated, however, at the expense of a smaller saving in the average read-access time. The impacts of process variations and technology scaling are also taken into account.     

Black hole entropy,the black hole information paradox,and time travel paradoxes from a new perspective

ABSTRACT

Relatively simple but apparently novel ways are proposed for viewing three related subjects: black hole entropy, the black hole information paradox, and time travel paradoxes. (1) Gibbons and Hawking have completely explained the origin of the entropy of all black holes, including physical black holes – nonextremal and in 3-dimensional space – if one can identify their Euclidean path integral with a true thermodynamic partition function (ultimately based on microstates). An example is provided of a theory containing this feature. (2) There is unitary quantum evolution with no loss of information if the detection of Hawking radiation is regarded as a measurement process within the Everett interpretation of quantum mechanics. (3) The paradoxes of time travel evaporate when exposed to the light of quantum physics (again within the Everett interpretation), with quantum fields properly described by a path integral over a topologically nontrivial but smooth manifold.     

Dynamic tensile mechanical properties and failure mode of zirconium diboride-silicon carbide ceramic composites

Dynamic indirect tension experiments were performed on zirconium diboride-silicon carbide (ZrB₂−20%SiC) ceramic. Flattened Brazilian disc specimens of ZrB₂−20%SiC were prepared to conduct dynamic tensile tests using the modified Split Hopkinson pressure bar system. The tensile experiments were completed at the range of loading rates from 7.53 to 74.71 GP s⁻¹. The tensile experimental results revealed that the zirconium diboride-silicon carbide ceramic composite is rate-sensitive in terms of the tensile strength and failure mode. The dynamic tensile strength increases linearly with the loading rate and changes from 195 MPa at 7.53 GP s⁻¹ to 654 MPa at 74.71 GP s⁻¹. Moreover, the dynamic tensile strength decreases with the increase in critical fracture time, which conforms to Tuler and Butcher's fracture criterion. In dynamic experiments, a high-speed camera was used to examine the tensile failure process, and fragments were collected to analyze the dynamic tensile failure mechanism. The tensile fracture mode of ZrB₂−20%SiC obviously showed the sensitivity of the loading rate. The fragment size of ZrB₂−20%SiC ceramic decreased but the quantity of fragments increased as the loading rate increased.     

One‐shot radical polymerization of vinyl monomers with different reactivity accompanying spontaneous delay of polymerization for the synthesis of double‐network hydrogels

Double‐network hydrogels were conveniently synthesized by the one‐shot radical polymerization of an ionic monomer for the first network and a non‐ionic monomer for the second network in the presence of crosslinkers by simultaneous addition of the monomers, that is, one‐shot and spontaneous two‐step polymerization accompanying the delay of polymerization of a second network monomer. We analyzed the polymerization process based on the conversion of each monomer during the reaction in the absence of crosslinkers. Then we fabricated the double‐network hydrogels using several polymerization systems consisting of a conjugated monomer and a non‐conjugated monomer in the presence of the dual crosslinkers. We analyzed the swelling, mechanical and viscoelastic properties of hydrogels synthesized by one‐shot radical polymerization to confirm the production mechanism and the network structure of the hydrogels. © 2020 Society of Chemical Industry     

基于多变量时间序列及向量自回归机器学习模型的水驱油藏产量预测方法

提出了一种基于多变量时间序列(MTS)及向量自回归(VAR)机器学习模型的水驱油藏产量预测方法,并进行了实例应用。该方法在井网分析的基础上通过MTS分析对注采井组数据进行优选,并将井组内不同采出井产油量及注入井注水量作为彼此相关的时间序列,通过建立VAR模型从多个时间序列中提取出相互作用规律,挖掘注采井间流量的依赖关系从而进行产量预测。水驱油藏历史生产数据分析结果表明,与数值模拟历史拟合结果相比,机器学习模型产量预测结果具有更高精度,同时不确定性分析提升了预测结果的安全性。通过脉冲响应分析对注入井的采油贡献量进行评价,可为注水开发方案调整提供理论指导。